Jump to content

Looking for: Grace 707 Tonearm anti skate weight


Recommended Posts

Any thoughts, suggestions or help gratefully received. 
 

cheers

chris 

Link to post
Share on other sites

Anything can be used for the weight on the end of a fine nylon thread.  A small nut, blob of bluetak, etc will all work fine. 

ProJect sell a replacement bias weight that's affordable, and probably the easiest available. 

 

Link to post
Share on other sites

Thanks. I checked out the project one but it’s not what I need. 
have attached a pic so you know what I mean. 
 

it’s a small donut  with a thumb screw to tighten 

 

cheers

chris 

 

 

6D9868D2-2F89-4D83-97AB-0F29E104D75E.jpeg

  • Like 1
Link to post
Share on other sites

Where about are you.

I have a spare tonearm you can have.

I cracked the mount where the tonearm lift goes by over-tightening it.

I'm located at Ipswich QLD.

  • Like 3
Link to post
Share on other sites

I am in the same search as you.

You could use also 840's ones they are similar or try to fabricate one ,they are about 2.4 grams as I remember and the hole for the post is 0.9 mm in diameter.

  • Like 1
Link to post
Share on other sites
Posted (edited)
9 hours ago, Pegasus said:

Where about are you.

I have a spare tonearm you can have.

I cracked the mount where the tonearm lift goes by over-tightening it.

I'm located at Ipswich QLD.

Amazing!  Thank you.  I am just round the corner. Karana Downs. 


* edited due to being an excitable dumbass. PM sent 

 

cheers 

chris 
 

Edited by W47ty
Link to post
Share on other sites
7 hours ago, Antipodean Brad said:

Chris,

 

It is advisable to not put phone numbers in posts: a PM (Personal Message) is the place to do it.

 

Hope it goes well.

 

You’re quite right. Excitement got the better of me whilst rushing around. Good tip duly noted. 
 

cheers 

Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.



×
×
  • Create New...