Jump to content

SOLD: FS: Halcro MC50


Recommended Posts

SOLD
Price: $2500
Item Condition: Fantastic
Shipping Options: Pickup available but audition is not available.,Pickup available and you can audition.,Shipping is included in price.
Suburb or Town: Brisbane Coorparoo
State: Queensland
Payment Method: Paypal, Bank Transfer, Cash
Reason for selling: Not being utilised

Unfortunately this just isn't being used anymore. Absolutely fantastic amp in surround or 2 channel. Works great to Bi-amp alone or with another amp like in my pic. Tube top and Halcro bottom was incredible on my Paradigms

Heaps of info about these here and online.

Recently replaced 1 module from Magenta at about $500 (great that this is so easily repaired. 4 screws)

RRP was about $7,000 USD when new

 

I have original double boxes to post and manual. Modules are very easy to turn on and off which is very handy to keep some spare if not being used

 

  • Power Output: 350W RMS continuous into 4 Ohms
  • Distortion THD: <0.007% at 1kHz at all powers up to 350W into 4 Ohms, <0.03% at 7kHz at all powers up to 350W
  • Unbalanced and Balanced Voltage Inputs
  • Thermally controlled forced air cooling
  • Mains Voltage: 190 – 250VAC
  • Remote trigger switch between On & Standby
  • Command Functions:
    • Switch between On & Standby
    • Ability to inhibit individual amplifier modules
    • Amplifier module will indicate Over Temperature condition
  • Halcro Reliability Assurance Service

 

 

SPECIFICATIONS:
Inputs, selectable

Unbalanced: RCA sockets

Balanced: XLR sockets

Outputs

Internally bridged: Binding Posts

 

Command Functions

Switch between On & Standby

Ability to inhibit individual amplifier modules

Amplifier module will indicate Over Temperature condition

Amplifier module will indicate Over Current condition

Halcro Reliability Assurance Service

 

Gain

Unbalanced and balanced: 29x = 29dB

 

Power Supply

Universal switch mode

Power factor corrected

Fully protected

Compliant in all countries

 

Fault Indications

LED turns red if Heatsink temperature exceeds 78°C

LED flashes red if current limit exceeded

 

Distortion

THD:<0.005% at 1kHz at all powers up to 350W into 4ohms

0.02% at 7kHz at all powers up to 350W (typically <0.01% at 350W)

Noise: <30nV/sqrt(Hz) @ 1kHz referred to input

 

Impedance
Input

Unbalanced: 10k Ohms

Balanced: 10k Ohms

Output impedance at 7kHz

<80 milliohms

 

Power
Consumption

Idle: <14W

350W with 4 Ohm load: <22W heat (>94% efficient)

 

Mains Voltage

100-250 VAC

 

Dimensions

Weight: 25.0 kg

Height: 7 inches or 169mm

Width: 17 inches or 438mm

Depth: 16 inches or 410mm

 

 

Please forgive my amateur pics but easy to see it is in very good condition

DSC03273.JPG

DSC03291.JPG

DSC03292.JPG

DSC03293.JPG

DSC03294.JPG

DSC03295.JPG

Link to comment
Share on other sites



Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...
To Top