Jump to content

Sign in to follow this  

Amp not coming out of standby. Help.

Recommended Posts

Hello! I'm new to the forum, and seeking some help. I have been given a Cutec L-200 amplifier. I've hooked it up,  etc.  On powering up,  it's showing as receiving good consistent signal, but no sound is being sent to speakers,  and the status light on the amp is showing as being in standby; red. instead of showing; in operation, green.


Has anyone got any experience with this amp? 



Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Similar Content

    • By ST3V3Z
      Trying to fix the issue with this Luxman amp.
      Takes a while to get out of protection on start-up. When outputting more than about 1W, speaker makes popping sound, if left playing, makes one really loud pop and turns itself back to protection mode.
      I took it open and got some pictures.
      Seems like the amp had been repaired before. One of the amp board looks like it's been blown up before.
      the main power transistors looks different on the power amps, is that a concern?  The 2SA679 is swapped for 2SB655A and 2SC1079 is swapped to 2SD675A.
      Any ideas what would be causing the issue?
      Any help is appreciated.

  • Create New...