Search the Community
Showing results for tags 't758'.
Found 1 result
Hey guy's, I need some help. I recently picked up a NAD T758 v3 receiver and set aside today to do the Dirac Live room correction. After hours i still cannot get a measurement it will use. I'm using the supplied mic on tripod stand and have tried it plugged into the T758 (as suggested by NAD) and also via my PC. The issue: Every time i run a measurement point (Test tones from each speaker), at the end i get a Low Signal to Noise ratio error message, regardless of which point i'm measuring and what volume everything is set at etc (I've tried almost all volume options!). The rooms quiet. no other appliances are running except the amp and my PC. I also leave the room during the measurement. The one time i was able to get enough measurement points successfully recorded, it failed during the filter design stage with an error saying the measurements were too poor quality. I've tried another calibration microphone (KRKSystems) with the exact same results as above. I've also tried it through the iOS app. Again, same issues. Has anyone else experienced this or have some suggestions? Thanks.
Currently Active Ads
Total Sales (Since 2018)
Total Sales Value (Last 14 Days)
Total Ads Value (Since March 2020)